Simple Doorbell Circuit with IC 555

This electronic schematic diagram is simple, you can use this schematic diagram as your simple electronic project. It’s easy and fun.

The main part of this doorbell circuit are two NE555 timer ICs. When  some one presses switch S1 momentarily ,the loud speaker sounds a bell tone as long as the time period of the monostable multivibrator built around IC1.

When the switch S1 pressed, IC1 is triggered at its pin 2 and output pin 3 goes high for a time period previously set by the values of POT R4 and POT R5.When the output ofIC1 goes high it resets IC2 and it starts to oscillate to make a bell sound through the speaker.The IC2 is configured as an astable multivibrator whose oscillation frequency can be varied with the help of POT R5.By adjusting the values of R4 & R5, modifications on the tone are possible.

Notes.

• The circuit has to assembled on a good quality PCB or common board.
• The IC1 & IC2 has to be mounted on IC holders.
• Power the circuit from a 9V battery or 9V DC power supply.
• Switch S1 is push button switch.

source: www.circuitstoday.com

Related Post:

• High Current Power Supply
  This power supply circuit can supply high current for your electronic project. Transistor 2N3055 is...
• LED Pulse Effect circuit
  This is an LED pulse effect circuit. The effect result of this circuit is that the LED goes from off...
• Simple LED Flasher circuit
  Here the simple LED flasher circuit that you can use for your simple project. schematic diagram: com...
• LED Flip Flop Project
  You're a newbie in electronics and you need to practice your electronics knowledge and then I sugge...
• Audio Power Amplifier 2-20 Watt Stereo
  This schematic is very simple, there is just need 1 active component in each channel (I mean right c...