AC adapter basics:
It seems that the world now revolves around AC Adapters or ‘Wall Warts’ as they tend to be called. There are several basic types. Despite the fact that the plugs to the equipment may be identical THESE CAN GENERALLY NOT BE INTERCHANGED. The type (AC or DC), voltage, current capacity, and polarity are all critical to proper operation of the equipment. Use of an improper adapter or even just reverse polarity can permanently damage or destroy the device. Most equipment is protected against stupidity to a greater or lessor degree but don’t count on it. The most common problems are due to failure of the output cable due to flexing at either the adapter or output plug end. See section below on repair procedure.

1. AC Transformer. All wall warts are often called transformers. However, only if the output is stated to be ‘AC’ is the device simply a transformer. These typically put out anywhere from 3 to 20 VAC or more at 50 mA to 3 A or more. The most common range from 6-15 VAC at less than an Amp.

You’re a newbie in electronics and you need to practice your electronics knowledge and then I suggest you to build this LED Flasher (Flip-Flop). This circuit is very simple and very easy to understand…

INTRODUCTION:

Flashing circuits are very interesting. They grab your attention and can be used in many applications. They consume very little energy and a single cell can last as long as 12 months. This is the simplest circuit capable of alternately flashing two LEDs.

SCHEMATIC DIAGRAM:

COMPONENT LIST:

Electrolytic capacitor or electrolytics condensator or we often call “ELCO” is a type of capacitor that uses an ionic conducting liquid as one of its plates. Typically with a larger capacitance per unit volume than other types, they are valuable in relatively high-current and low-frequency electrical circuits. This is especially the case in power-supply filters, where they store charge needed to moderate output voltage and current fluctuations, in rectifier output. They are also widely used as coupling capacitors in circuits where AC should be conducted but DC should not.

Electrolytic capacitors can have a very high capacitance, allowing filters made with them to have very low corner frequencies.

Electrolytic Capacitor Construction

Aluminum electrolytic capacitors are constructed from two conducting aluminum foils, one of which is coated with an insulating oxide layer, and a paper spacer soaked in electrolyte. The foil insulated by the oxide layer is the anode while the liquid electrolyte and the second foil act as cathode. This stack is then rolled up, fitted with pin connectors and placed in a cylindrical aluminium casing. The two most popular geometries are axial leads coming from the center of each circular face of the cylinder, or two radial leads or lugs on one of the circular faces. Both of these are shown in the picture.