Circuit Description:
This amplifier uses a dual 20 Volt power supply and delivers 15 watts RMS into an 8 ohm load. Q1 operates in common emitter, the input signal being passed to the bias chain consisting of Q8, Q9, D6, D13 and D14. Q8 and Q9 provide a constant current through the bias chain to minimize distortion, the output stage formed by a discrete darlington pair (Q2,Q4) and (Q7,Q11). The last two transistors are power transitors, specifically the 2N3055 and MJ2955. The 7.02K resistor, R16 was made using a series combination of a 4.7K, 680 Ohms, and two 820 Ohms. The 1.1K resistor, R3 was made using a 100 Ohms and a 1K resistor. You can use this circuit with any walkman or CD player since it is designed to take a standard 500mv RMS signal.

Figure 1 above shows proper soldering technique. The diagram shows the tip of the soldering iron being inserted into the joint such that it touches both the lead being soldered and the surface of the PC board.

Then, solder is applied into the joint, not to the iron directly. This way, the solder is melted by the joint, and both metal surfaces of the joint (the lead and the PC pad) are heated to the necessary temperature to bond chemically with the solder.

Here simple 20 Watt – 40 Watt inverter circuit diagram which able to convert 12V DC become 110V or 220V AC.

Tips :

First wire to oscillator part only.
Then check out put Pin 10 &11 of CD4047 to obtain the required wave forms ( two 120Hz ,180 degree out of phase,50% duty cycle waves.
Then connect transistors ,transformer and load (25 W bulb for test).See it working!.

Power supply is a must used circuits. Most of electronic devices which require DC voltage usually need a power supply. Some of them just need original power supply or battery, but some of circuits like Radio transmitter or amplifier needs high current output power supply.

This project is a simple and easy made 5 ampere power supply. To build this circuit, just follow the instruction below:

You’re a newbie in electronics and you need to practice your electronics knowledge and then I suggest you to build this LED Flasher (Flip-Flop). This circuit is very simple and very easy to understand…

INTRODUCTION:

Flashing circuits are very interesting. They grab your attention and can be used in many applications. They consume very little energy and a single cell can last as long as 12 months. This is the simplest circuit capable of alternately flashing two LEDs.

SCHEMATIC DIAGRAM:

COMPONENT LIST: